The RDG-SIM simulates up to four wheel speed sensors in parallel. All conventional wheel speed sensors are programmable and can be completed by analogue signal driver. The RDG-SIM is easy to handle, only a few basic parameters have to be configured (number of channels, increment number, wheel circumference). It is available both as a single device in a desktop housing and as a 19-inch module.
Wheel speed simulation RDG-SIM
- Development and testing of control units (e.g. ABS, ESP, ASR)
- Development of application software independent of real sensors
- Use in driving simulators
- Environmental simulation on test benches (e.g. chassis test, vibration test bench)
- Testing of sensor evaluation circuits
- One module for all types of wheel encoders, VDA-standardised data protocol
- One to four channels, also mixed operation of different sensor types possible
- Storage of channel-related speed curves (speed profiles)
- Remote control via USB and CAN
- The standard simulation reproduces the typical behaviour of the selected sensor type as well as the status codes supported by the real sensor
- A limit error simulation allows the manipulation of amplitude and timing parameters even beyond the typical tolerance limits (signal range check and logical errors)
- Available as a single device in a table housing and as a 19-inch assembly
- Four independent channels simulation
- Simulation of wheel-speed sensors of all current sensor types, from increment sensors to complex sensor types that work with PSI5 signals
- Target of constant speeds and speed ramps
- Simulation until 300 km/h
- Up to 300 teeth per revolution
- Adjustable wheel circumference between 1 and 2.5 m
- Channel outputs individually switched off
- Standard simulation: Reflects the typical behavior of the selected sensor type as well as the error codes supported by the real sensor
